Iec 61850 Engineering Procedure; Iec 61850 Protocol References And Pre-Conditions; Sequence For Engineering Of Iec 61850 Protocol - ABB Relion 670 series Engineering Manual

Section 7
IEC 61850 communication engineering
7.2
7.2.1
7.2.2
72
• Capability description of the IED in logical nodes and their data. No
information about communication configuration, for example, is included.
• An IED is already extended by default data sets. They are predefined by
ABB. Changes or additional data sets, for example, have to be done with
the IET600 station configuration tool.
• SCD = Station Configuration Description
• Complete configuration description of all IEDs in a station and the full
engineering of process signals and communication structure is included.
This includes all needed data sets and all control blocks.
• CID = Configured IED Description
• The CID file contains the information needed to configure just one
specific IED.
The uploading of IEC 61850 communication configuration is not
supported when reading a configuration from an online IED.

IEC 61850 engineering procedure

IEC 61850 protocol references and pre-conditions

To engineer the IEC 61850 protocol interface for the IED, the following additional
manuals or knowledge of their contents is required.
• Knowledge of the IEC 61850 engineering process as described in the IEC
61850 standard.
• The IEC 61850 conformance documents for the IED to be engineered.
• The Technical reference manual describes function blocks defined as logical
nodes.
• IEC 61850 Data objects list for 670 series.

Sequence for engineering of IEC 61850 protocol

The IEC 61850 standard defines the complete part needed for information
communication in a substation. This can be split into the following parts:
• Description of the substation part including the used logical nodes
• Description of the IEDs with their logical nodes
• Description of the communication network
• Description of the engineering process
1MRK511240-UEN B
670 series
Engineering Manual