1MRK511240-UEN B
670 series
Engineering Manual
IEC09000656 V1 EN
Figure 39:
LHMI: Function key operation mode
The LEDs have a number of different operation modes, see
•
Follow-S
•
The LED illumination follows the status of the signal. The LED
illuminates steady (S).
•
Follow-F
•
The LED illumination follows the status of the signal. The LED
illuminates flashing (F).
•
LatchedAck-F-S
•
The LED latches the signal change OFF-ON and flashes (F) until it is
acknowledged.
•
When the signal is still ON at the time the signal is acknowledged the
LED changes to steady (S) mode.
•
When the signal has already changed to OFF before the time it is
acknowledged, the LED turns to OFF.
•
LatchedAck-S-F
•
The same as LatchedAck-F-S but the LED starts with steady state and
flashes after acknowledgment.
•
LatchedColl-S
•
The LED illuminates in all cases in steady mode only
•
The LED latches a signal change from OFF-ON until it is acknowledged
by the operator.
•
The LED stays in steady mode when it is reset and the signal is still in
ON state.
•
The LED is OFF only after the signal has changed to OFF state AND it
is reset by the operator via 'Clear' operation.
•
LatchedReset-S
•
This mode is used for all LEDs that are used to indicate a disturbance.
The LEDs will stay in the last state after the disturbance run time until
they are reset after a defined time.
•
The timers are set in PST in the function block LEDGEN.
Section 6
Local HMI engineering
IEC09000656-1-en.vsd
Figure
40:
57