The Qos Shaper Setup Screen - ZyXEL Communications VMG5313-BXB SERIES User Manual

Table 50 Classification Setup: Add/Edit (continued)
LABEL
Step5: Outgoing Queue Selection
To Queue
OK
Cancel

10.6 The QoS Shaper Setup Screen

This screen shows that you can use the token bucket algorithm to allow a certain amount of large
bursts while keeping a limit for processing outgoing traffic at the average rate. Click Network
Setting > QoS > Shaper Setup. The screen appears as shown.
Figure 73 Network Setting > QoS > Shaper Setup
The following table describes the labels in this screen.
Table 51 Network Setting > QoS > Shaper Setup
LABEL
Add New
Shaper
#
Status
Outgoing
Interface
Rate Limit
(kbps)
Modify
Chapter 10 Quality of Service (QoS)
DESCRIPTION
Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
Click this to create a new entry.
This is the index number of the entry.
This field displays whether the shaper is active or not. A yellow bulb signifies that this
policer is active. A gray bulb signifies that this shaper is not active.
This shows the name of the VMG's interface through which traffic in this shaper applies.
This shows the average rate limit of traffic bursts for this shaper.
Click the Edit icon to edit the shaper.
Click the Delete icon to delete an existing shaper. Note that subsequent rules move up by
one when you take this action.
VMG5313-BXB Series User's Guide
152