Table of Contents
Advertisement
Table 70 Classification Setup: Add/Edit (continued)
LABEL
802.1P Mark
Step4: Class Routing
Forward to
Interface
Step5: Outgoing Queue Selection
To Queue Index
Cancel
OK
10.6 The QoS Shaper Setup Screen
This screen lets you use the token bucket algorithm to allow a certain amount of large bursts of traffic
while keeping most outgoing traffic at the average rate. Click Network Setting > QoS > Shaper Setup.
The screen appears as shown.
Figure 129 Network Setting > QoS > Shaper Setup
The following table describes the labels in this screen.
Table 71 Network Setting > QoS > Shaper Setup
LABEL
Add New
Shaper
#
Status
Outgoing
Interface
Rate Limit
Modify
Chapter 10 Quality of Service (QoS)
DESCRIPTION
Select a priority level with which the Zyxel Device replaces the IEEE 802.1p priority field in the
packets.
If you select Unchange, the Zyxel Device keep the 802.1p priority field in the packets.
Select a WAN interface through which traffic of this class will be forwarded out. If you select
Unchange, the Zyxel Device forward traffic of this class according to the default routing table.
Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Click Cancel to exit this screen without saving.
Click OK to save your changes.
DESCRIPTION
Click this to create a new entry.
This is the index number of the entry.
This field displays whether the shaper is active or not. A yellow bulb signifies that this policer is
active. A gray bulb signifies that this shaper is not active.
This shows the name of the Zyxel Device's interface through which traffic in this shaper applies.
This shows the average rate limit of traffic bursts for this shaper.
Click the Edit icon to edit the shaper.
Click the Delete icon to delete an existing shaper. Note that subsequent rules move up by one
when you take this action.
VMG/XMG Series User's Guide
215
Advertisement
Table of Contents
