Qos Shaper Setup - ZyXEL Communications AX Series User Manual

Table 91 Network Setting > QoS > Classification Setup > Add New Classification/Edit (continued)
LABEL
To Queue Index
Cancel
OK

12.6 QoS Shaper Setup

This screen lets you use the token bucket algorithm to allow a certain amount of large bursts of traffic
while keeping most outgoing traffic at the average rate. Click Network Setting > QoS > Shaper Setup.
The screen appears as shown.
Figure 163 Network Setting > QoS > Shaper Setup
The following table describes the labels in this screen.
Table 92 Network Setting > QoS > Shaper Setup
LABEL
Add New
Shaper
#
Status
Interface
Rate Limit
Modify
Chapter 12 Quality of Service (QoS)
DESCRIPTION
Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Click Cancel to exit this screen without saving any changes.
Click OK to save your changes.
DESCRIPTION
Click this to create a new entry.
This is the index number of the entry.
This field displays whether the shaper is active or not. A yellow bulb signifies that this policer is
active. A gray bulb signifies that this shaper is not active.
This shows the name of the Zyxel Device's interface through which traffic in this shaper applies.
This shows the average rate limit of traffic bursts for this shaper.
Click the Edit icon to edit the shaper.
Click the Delete icon to delete an existing shaper. Note that subsequent rules move up by one
when you take this action.
AX/DX/EX/PX Series User's Guide
321