10.6.1 Add/Edit a QoS Shaper
Click Add New Shaper in the Shaper Setup screen or the Edit icon next to a shaper to show the
following screen.
Figure 74 Shaper Setup: Add/Edit
The following table describes the labels in this screen.
Table 52 Shaper Setup: Add/Edit
LABEL
Enable
Outgoing
Interface
Rate Limit
OK
Cancel
10.7 The QoS Policer Setup Screen
Use this screen to view QoS policers that allow you to limit the transmission rate of incoming traffic
and apply actions, such as drop, pass, or modify the DSCP value for matched traffic. Click Network
Setting > QoS > Policer Setup. The screen appears as shown.
Figure 75 Network Setting > QoS > Policer Setup
Chapter 10 Quality of Service (QoS)
DESCRIPTION
Select the check box to activate this shaper.
Select the VMG's interface through which traffic in this shaper applies
Enter the average rate limit of traffic bursts for this shaper.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
VMG5313-BXB Series User's Guide
153