Remote Usb Operation; Introduction; Bus Connections - Keysight V3500A User Manual

Remote USB Operation

Introduction

Bus connections

V3500A User's Guide
The V3500A is USB programmable. Commands and functions
accessible from the front panel are also available over USB,
except the following:
• On and off
• Save state
• Recall state
• Shutdown time setting
• Backlight off time setting
The driver for the V3500A is not complicated — a few
commands are necessary to initiate a connection and read
and write from the instrument. Device programming is
accomplished by sending and receiving strings over
the USB. This programming model is very similar to
GPIB programming.
You need to install the required drivers (See
Installation" on page
Then, connect the USB connector on the bottom side of the
V3500A to the USB connector of the controller (see
port" on page 7).
Driver Installation and Commands
27) before using the V3500A remotely.
3
"Driver
"USB
47