Banner SureCross DX80 FlexPower Manual

SureCross DX80 FlexPower Thermocouple Node
IP20 Base
900 MHz
For additional information, the most recent version of all documentation, and a complete list of accessories, refer to Banner Engineering's
website, www.bannerengineering.com/surecross.
Models
Model Frequency
DX80N9X2S2N2T 900 MHz ISM Band
DX80N2X2S2N2T 2.4 GHz ISM Band
DX80N9X2S2N2TC 900 MHz ISM Band IP20, NEMA 1
DX80N2X2S2N2TC 2.4 GHz ISM Band
Internal antenna models are also available. For more information, contact your local Banner Engineering Corp. representative.
WARNING: Not To Be Used for Personnel Protection
Never use this product as a sensing device for personnel protection. Doing so could lead to seri-
ous injury or death. This product does NOT include the self-checking redundant circuitry necessary to
allow its use in personnel safety applications. A sensor failure or malfunction can cause either an ener-
gized or de-energized sensor output condition.
P/N 131297 rev. I
The SureCross® wireless system is a radio frequency network with integrated I/O that
can operate in most environments and eliminate the need for wiring runs. Wireless net-
works are formed around a Gateway, which acts as the wireless network master device,
and one or more Nodes.
• Wireless industrial I/O device with up to three configurable thermocouple inputs (de-
faults to J-type), two selectable discrete inputs, and two NMOS discrete outputs
• One thermistor input used for integrated cold junction compensation (CJC)
• FlexPower® power options allows for +10 to 30V dc, solar, and battery power sour-
ces for low power applications.
IP67 Base
2.4 GHz
• DIP switches for user configuration
• Frequency Hopping Spread Spectrum (FHSS) technology and Time Division Multi-
ple Access (TDMA) control architecture ensure reliable data delivery within the unli-
censed Industrial, Scientific, and Medical (ISM) band
• Transceivers provide bidirectional communication between the Gateway and Node,
including fully acknowledged data transmission
• Lost RF links are detected and relevant outputs set to user-defined conditions
• The DX80...C models are certified for use in Class I, Division 2, Group A, B, C, D;
Zone 2 (Category 3G) Hazardous Locations when properly installed in accordance
with the National Electrical Code, the Canadian Electrical Code, or applicable local
codes/regulations (see Specifications)
Environmental Rating
IP67, NEMA 6
Class I, Division 2, Group A, B, C, D Haz-
ardous Locations (see Specifications)
10/12/2012
I/O
Inputs: Three thermocouople, two select-
able discrete, one thermistor input for
CJC
Outputs: Two NMOS sinking discrete
0 131297 3