Replacing The Integrated Battery (Dx80 Models); Replacing The Battery (Dx99 - Banner SureCross DX80 Product Manual

SureCross DX80 and Performance DX80 Product Manual

9.3.2 Replacing the Integrated Battery (DX80 Models)

To replace the lithium "D" cell battery in any integrated housing model, follow these steps.
1. Remove the four screws mounting the face plate to the housing and remove the face plate.
2. Remove the discharged battery by pressing the battery toward the negative terminal to compress the spring. Pry up on
the battery's positive end to remove from the battery holder.
3. Replace with a new battery. Only use a 3.6V lithium battery from Xeno, model number XL-205F.
4. Verify the battery's positive and negative terminals align to the positive and negative terminals of the battery holder
mounted within the case. The negative end is toward the spring.
Caution: There is a risk of explosion if the battery is replaced incorrectly.
5. After replacing the battery, allow up to 60 seconds for the device to power up.
6. Properly dispose of your used battery according to local regulations by taking it to a hazardous waste collection site, an
e-waste disposal center, or other facility qualified to accept lithium batteries.
9.3.3 Replacing the Battery (DX99...D Models)
To replace the lithium "D" cell battery in the metal housings with integrated batteries, follow these steps.
1. Unscrew the lid of the metal enclosure.
2. Disconnect the radio by unplugging the ribbon cable from the radio board. The radio board is mounted inside the metal
lid.
3. Remove the discharged battery by pressing the battery towards the negative terminal to compress the spring. Pry up
on the battery's positive end to remove from the battery holder.
4. Replace with a new battery. Only use a 3.6V lithium battery from Xeno, model number XL-205F.
5. Verify the battery's positive and negative terminals align to the positive and negative terminals of the battery holder
mounted within the case. Caution: There is a risk of explosion if the battery is replaced incorrectly.
6. Wait two minutes.
7. Plug the ribbon cable back into the radio board.
8. Screw on the lid and tighten.
9. After replacing the battery, allow up to 60 seconds for the device to power up.
10. Properly dispose of your used battery according to local regulations by taking it to a hazardous waste collection site, an
e-waste disposal center, or other facility qualified to accept lithium batteries.
Rev. J
As with all batteries, these are a fire, explosion, and severe burn hazard. Do not
burn or expose them to high temperatures. Do not recharge, crush, disassem-
ble, or expose the contents to water.
The battery may be replaced in explosive gas atmospheres.
Replacement battery model number: BWA-BATT-001. For pricing and availabili-
ty, contact Banner Engineering.
As with all batteries, these are a fire, explosion, and severe burn hazard. Do
not burn or expose them to high temperatures. Do not recharge, crush, disas-
semble, or expose the contents to water.
Replacement battery model number: BWA-BATT-001. For pricing and availabili-
ty, contact Banner Engineering.
www.bannerengineering.com - tel: 763-544-3164 79