Table of Contents
Advertisement
8
Opening the value input screen
9
Setting the upper-limit value
10 Saving the upper-limit value
☆ Key Points of the Procedure ☆
1.
The limit values you have set can be checked each time you press the
The balance displays the lower-limit value after showing [L.
SEt ].
showing [H.
Lower limit value
displayed
2.
If you make a mistake, press the
Set
key during the setup of values.
3.
If you press the
the weight currently loaded on the balance. Pressing the
the value input screen.
4.
If the [
] mark lights up for all three judgement indicators, HI, OK, and LO, the lower-limit value
set exceeds the upper-limit value. Check the values, since mistakes can occur with entries, as
in cases when the upper-limit value is specified with a negative sign.
5.
When the [M] mark is flashing on the value input screen, the sign on the left end can be changed.
Press the
Zero/Tare
26
Upper-limit value
Function
Memory
key while a value is flashing, an actual quantity will be set based on
key to switch between the positive and negative signs.
Press the
Follow the same procedure as in "Step
2."
Follow the same procedure as
described for the lower-limit value and
enter the upper-limit value.
Press the
After saving the upper-limit value, the
balance displays it briefly and
terminates setup.
SEt ], and the upper-limit value after
Measurement mode
displayed
key during the setup of actual quantities or the
Zero/Tare
Zero/Tare
key.
Memory
key.
Set key.
restored
key at this time displays
Advertisement
Table of Contents
