Table of Contents
Advertisement
Setup of units of
measurement to
※
1
be displayed
Display of the
auxiliary scale
interval
GLP-compliant
2
※
print
Output format
while the auxiliary
scale interval is
displayed
☆1-☆5: default factory settings [81.S.u.]-[85.S.u.]
※ 1
Can be set only for a model on which the lock switch is off.
For a model on which the lock switch is on, only the units set when the switch was off are
effective.
※ 2
This setting is only available with the HYPROP BALANCE Series.
4.3 Interface Section
Displayed when [7.
Item
Output Control
Baud Rate
Parity
☆ denotes a factory-setting
※ The data interval in continuous output mode is 0.1 to 1 second. (The interval varies depending
on weighting conditions and other factors.)
14
☆3 20 [Pcs]
81.S.u.
☆4 IF [%]
|
☆5 00 Unit not set
85.S.u.
0 Disable
9. Ai
☆1
☆0 Disable Prints a GLP-compliant format at calibration.
0.GLP
1 Enable
1
A.PrF
2
☆3
I.F.
] is set to [1] or [2]
Set Value
0 Stop output
1 Output continuous at all times
2 Output continuous if stable (stop output if unstable)
3
4
71. o.c.
5
6
☆7
☆1 1200 bps
2 2400 bps
72.b.L.
3 4800 bps
4 9600 bps
☆0 None
73.PA.
1 Odd
2 Even
Enable (
is the auxiliary scale interval.)
Note: The auxiliary-scale-interval place does not
represent a verification scale interval. Use it
only as a reference value.
(Refer to "9.3 GLP-compliant print" (Page 31).)
No output is made while the auxiliary scale interval is
displayed.
Output is made even while the auxiliary scale interval is
displayed.
Output is made with "/" added to the left of the
auxiliary-scale-interval place.
Outputs once by pressing
of whether stable).
Outputs once if stable. Outputs if the balance is stable
when a sample is loaded after the preceding sample
has been removed and the balance indicated zero, or
less.
Outputs once if stable, and stops output when unstable.
Even if the sample is not replaced, the balance is output
once when it stabilizes next time (including the zero
indication).
Outputs once if stable, and outputs continuously when
unstable. Even if the sample is not replaced, output of
the balance stops when it stabilizes after being output
once.
Pressing
Memory
once when stable.
Displayed only when [7. I.F. 2
(7-digit numeric format)] is specified.
Description
Memory
key (irrespective
key causes the balance to output
Advertisement
Table of Contents
