Table of Contents
Advertisement
4.2 Description of Functions
Item
Bar graph display
Limit function
Judgement
condition
Judgement
range
Number of
points for
judgement
Auto-zero
(zero-tracking)
Auto power-off
Response speed
Stability parameters
Interface
Setup of units of
measurement to be
1
※
displayed
Register selected
measuring units with
Function
key.
☆ are the default factory settings. ☆ 1- ☆ 5: default settings [81.S.u.]-[85.S.u.]
Items marked
Set Value
0 Disable
1. b.G.
☆1 Enable
☆0 Disable
2.SEL
1 Enable
☆1
21.Co.
2
0
22.Li.
☆1
23.Pi.
1 One-point setup (judges between OK and LO)
☆2
0 Disable This function automatically sets the zero point
3. A.0
☆1 Enable
0
4. A.P.
☆1
0 Measurement by consecutive weighings.
1
2
5. rE.
☆3
4
5
1
☆2
6. S.d.
3
4
0 Disable input/output
☆1 Six-digit numeric format
7. I.F.
2 Seven-digit numeric format
☆1 01 [ g ]
☆2 14 [
15 [
16 [
17 [
81.S.u.
|
18 [
85.S.u.
1A [
1b [
1C [
1d [mom]
1E [
Description
Always judge (judges even when the balance is
unstable)
Judge only when the balance is stable (does not judge
if the balance is unstable)
Ranges beyond +5 graduation is judged (ranges +5
graduation or below, including negative ranges, are
not judged.)
The entire range is judged (the entire range, including
the negative, is judged).
Upper-limit and lower-limit values are set up (judges
among HI, OK and LO).
exactly to zero to prevent slight deviations.
Disable (balance operates
continuously)
Enable (balance powers off in
approximately three minutes)
Fast
Slow
Wide (mild)
Narrow (strict)
] (ct)
] (oz)
] (lb)
] (ozt)
] (dwt)
] (tl_Hong Kong)
Upper right] (tl_Singapore,Malaysia)
Lower right] (tl_Taiwan)
] (to)
This function is
available only when
the balance is
battery-operated.
13
Advertisement
Table of Contents
