Table of Contents
Advertisement
F676
FP
(FP Terminal) Pulse Output Function
Program Terminal FP Terminal Settings
This parameter sets the functionality of the FP output terminal to any one of the
user-selectable functions listed in
As the assigned function changes in magnitude or frequency, the pulse count of
the FP output terminal pulse train changes in direct proportion to changes in the
assigned function.
Note:
The duty cycle of the output pulse train remains at 65 ±5.0 µS.
This parameter is used in conjunction with parameter F677.
(FP Terminal) Pulse Output Frequency
Program Terminal FP Terminal Settings
This parameter scales the FP output terminal by setting the pulses-per-second
output signal of the FP terminal.
See
F676
for more information on this parameter.
Optional Analog Terminal Mark
Program Special Special Parameters
Not Used.
Current/Voltage Units Setup
Program Utilities Display Parameters
This parameter sets the unit of measurement for current and voltage values
displayed on the EOI.
Settings:
0 — %
1 — A/V
Free Unit Multiplication Factor
Program Utilities Display Parameters
This parameter provides a multiplier for the displayed speed value shown on the
EOI of the ASD.
This parameter may be used to display the rate that a commodity is being
processed by the driven load in process units (i.e., units/time).
Example: An output frequency of 100 Hz would be displayed as 50 Hz if
Note:
196
Table 9 on pg.
using a multiplier of 0.5 for this parameter.
PID frequency-limiting parameters are not affected by this
setting (i.e., F364, F365, F367, and F368).
221.
Direct Access Number — F676
Parameter Type — Selection List
Factory Default — Output Frequency
Changeable During Run — Yes
Direct Access Number — F677
Parameter Type — Numerical
Factory Default — 3840
Changeable During Run — Yes
Minimum — 1000
Maximum — 43200
Units — kHz
Direct Access Number — F680
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 3
Direct Access Number — F701
Parameter Type — Selection List
Factory Default — %
Changeable During Run — Yes
Direct Access Number — F702
Parameter Type — Numerical
Factory Default — 0.00 (Off)
Changeable During Run — Yes
Minimum — 0.00 (Off)
Maximum — 200.00
GX9 ASD Installation and Operation Manual
F702
Advertisement
Table of Contents
