Toshiba GX9 Installation & Operation Manual page 157

F371
Position Loop Gain
Program Feedback PG Settings
This parameter provides a divisor for the pulse input when operating in the
Pulse Control mode.
Positioning Completion Range
Program Feedback PG Settings
During a deceleration ramp, this parameter sets a position range that must be
attained before the Stop command may be executed.
Frequency Limit at Position
Program Feedback PG Settings
While operating in the Position-Control mode and using PG feedback, this
setting determines the maximum acceleration rate in Hz/second.
Current Control Proportional Gain
Program Feedback PG Settings
This parameter sets the sensitivity of the drive when monitoring the output
current to control speed. The larger the value entered here, the more sensitive
the drive is to changes in the received feedback.
Current Control Integral Gain
Program Feedback PG Settings
This parameter sets the degree and rate at which the output frequency will be
allowed to change when prompted by changes in the output current.
The larger the value entered here, the quicker/more the drive responds to
changes in feedback.
GX9 ASD Installation and Operation Manual
Direct Access Number — F371
Parameter Type — Numerical
Factory Default — 4.00
Changeable During Run — Yes
Minimum — 0.0
Maximum — 100.0
Direct Access Number — F372
Parameter Type — Numerical
Factory Default — 100
Changeable During Run — Yes
Minimum — 1
Maximum — 4000
Direct Access Number — F373
Parameter Type — Numerical
Factory Default — 800
Changeable During Run — Yes
Minimum — 1
Maximum — 8001 (Disabled)
Units — Hz/Second
Direct Access Number — F374
Parameter Type — Numerical
Factory Default — (ASD-Dependent)
Changeable During Run — No
Minimum — 100.0
Maximum — 1000
Direct Access Number — F375
Parameter Type — Numerical
Factory Default — (ASD-Dependent)
Changeable During Run — No
Minimum — 100.0
Maximum — 1250
F375
145