Table of Contents
Advertisement
WIRE, CABLE AND HOSE ROUTING 16-13
Overflow/Vent hoses and Carburetor vent hoses
Coolant Reservoir
The coolant overflow/air bleeder line is attached to the reservoir
with a black spring clamp. The overflow hose is then routed
downwards along the length of the reservoir and through a guide
to a position that is between the coolant hose and the engine.
Fuel Tank
The fuel tank overflow line is routed from the gas cap itself
under the handlebar and through the top plate of the steering
column.
The hose is then tied to the rest of the handlebar accessory
wires with a nylon tie wrap to secure it in place. The hose is
then routed to the MAG side of the MPEM.
At this point, the hose is routed between the two carburetors,
under the PTO-most coolant hose, through the triangular PTO
chassis cut-out and is then secured to the chassis with a nylon
tie wrap near the brake system.
Advertisement
Table of Contents
