Table of Contents
Advertisement
PRIMARY TRANSMISSION SYSTEM 8-14
Torque screws to 10 N•m (89 lbf•in)
o
32, 30, 29, 25, Screw, Lever Ass'y, Nut Cotter Pin
NOTICE:
While installing lever assemblies make sure that the curved
sides of the levers are outwards as shown.
Always install lever assemblies so that cotter pins are
o
on the shown side. Besides install cotter pin head on the
top when lever is sat at bottom of sliding half. Bend
cotter pin ends to sit perfectly against lever.
Whenever replacing centrifugal levers, always replace all
3 at the same time. Otherwise, drive pulley misbalancing
will occur because of levers difference.
Lever assemblies must be installed so that cotter pins are
on the same side.
Torque nuts to 12 N•m (106 lbf•in)
o
WARNING
CAUTION
1- Equal distance
1- Head on top
2- All on the same side
Advertisement
Table of Contents
