Table of Contents
Advertisement
WIRE, CABLE AND HOSE ROUTING 16-2
WIRE, CABLE AND HOSE ROUTING
Make sure that all the wires are well set in the terminals
and that the connector holders are well installed. Keep
the wires away from any rotating, moving, heating or
vibrating part. If necessary, use good retaining devices.
When reassembling, it is important to always re-install the
wires to the stock positions.
SPARK PLUG WIRES AND MPEM
When changing the ignition coil or either of the ignition wires, it
is important that the wires are re-installed in exactly the same
position.
The two ignition wires must be installed as shown at
o
right.
The ignition coil power connector connects to the MPEM
o
in the first 2-pin connector from the front of the vehicle
as shown at right.
WARNING
The MPEM has a built in key guide at each socket to
ensure that the correct connectioins find their place. If
there is difficulty to make a connection with one of the
housings, check the wiring diagram to make sure the
location is correct.
WARNING
Advertisement
Table of Contents
