Table of Contents
Advertisement
ENGINE (CYLINDERS / HEAD / BASE / EXHAUST) 7 - 22
Screw all crankcase bolts in place in the following sequence and
to the appropriate torque; this must be done in two steps,
torquing: first, screw bolts up to 60% of the final torque (18 N-m
(13.5 lbf-ft) for most of the bolts), then, tighten to the required
torque (i.e. 29 N-m (21 lbf-ft)).
A. Torque bolts 1 through 16 to 29 N-m (21 lbf-ft)
B. Torque bolts 17 through 21 to 9 N-m (80 lbf-in)
793 HO Engine Types
Install oil seal cover
BREAK-IN
After rebuilding an engine, always observe a break-in
period as described in Chapter 1 – General Instructions.
Advertisement
Table of Contents
