Table of Contents
Advertisement
FUEL SYSTEM 3 - 16
CLEANING AND INSPECTION
Check fuel pump valves operation as follows:
The entire pump should be cleaned with general-purpose
solvent before disassembly.
Fuel pump components should be cleaned in general purpose
solvent and dried with compressed air.
Solvent with a low flash point such as gasoline, naphtha,
benzol, etc., should not be used as each is flammable and
explosive.
Inspect diaphragm. The pumping area should be free of holes,
tears or imperfections. Replace as needed.
INSTALLATION
Inverse removal procedure.
Perform a pressure test to ensure there is no leak in the
fuel system.
WARNING
WARNING
Advertisement
Table of Contents
