Table of Contents
Advertisement
PRIMARY TRANSMISSION SYSTEM 8-24
DRIVE BELT
MODEL
SNOW HAWK
DIRECTION OF ROTATION
In order for the drive-belt to last as long as possible it must be
installed as is shown in the illustration respecting the direction of
rotation.
NOTICE:
In the case of a belt that has already been used, mark it and
reinstall it such that it will be used in the same direction.
DRIVE BELT HEIGHT MEASUREMENT AND ADJUSTMENT
Measurement
NOTE: The drive belt height measurement must be performed
each time a new drive belt is installed.
NOTE: To obtain an accurate drive belt height measurement, it
is suggested to allow a break-in period of 50 km (30 m).
Before checking the belt height, ensure that a good-
o
condition proper belt (refer to the Application Chart) is
installed.
Adjust pulley distance and alignment. Refer to PULLEY
o
DISTANCE AND ALIGNMENT.
To obtain maximum vehicle performance. The belt
o
height must be adjusted according to specifications
shown in the accompanying chart.
P/N
144-4740U3
WIDTH NEW
1.375 ± 0.030
SNOW HAWK
SNOW HAWK
M o d e l
D e f l e c t i o n
m m
S n o w H a w k 3 2 ( 1 1 / 4 )
1- Flush
MINIMUM WIDTH
(WEAR LIMIT)
1.250 ± 0.030
F o r c e
( i n )
k g
( l b )
6 . 8 ( 1 5 )
Advertisement
Table of Contents
