Table of Contents
Advertisement
All engines are equipped with cageless piston pin
Bearings, as shown at right.
Once the head and cylinder(s) has been removed, Use piston pin
puller (P/N 529 035 503) along with 20 mm sleeve kit (P/N 529
035 542). Use also a locating sleeve.
NOTICE:
The locating sleeve is the same that contains new cageless
bearing.
Insert piston pin puller (P/N 529 035 503) making
sure it sits squarely against piston as shown at right.
Install sleeve (1) then shouldered sleeve (2) over puller
rod as shown at right.
ENGINE (CYLINDERS / HEAD / BASE / EXHAUST) 7 - 11
TYPICAL
1. Properly seated all around
TYPICAL – INSTALLATION OF SLEEVE KIT
1. Sleeve
2. Shouldered sleeve
1
1
2
Advertisement
Table of Contents
