Table of Contents
Advertisement
Pulley Half Cleaning
Use pulley flange cleaner (P/N 421 711 809)
o
INSPECTION
11, 12, Slider Shoe
Check cam slider shoes for wear. Replace when inside edge
thickness of cam slider shoe slope base is worn to 1 mm
(0.039in) or less.
REASSEMBLING
11, 12, Cam Slider Shoe
When replacing slider shoes, always install a new set
o
(3 shoes) to maintain equal pressure on the cam.
Install slider shoes as per following photo. RED slider
o
shoes are being used for reverse and BLACK ones for
forward.
22, Screws
These screws are machined at their end. With the adjustment
ring steel to position 0 (zero), screw ends are flush with inner
side of fixed pulley half when tighten.
If any of these screws is not flush with inner side of
sliding pulley, bushings will worn unequally.
Assemble driven pulley components by reversing the
o
disassembly procedure.
CAUTION
PRIMARY TRANSMISSION SYSTEM 8-21
1- Measure thickness of slope base here
2- Sliding pulley side
3- Slope base
1- BLACK slider shoe
2- RED slider shoe
Advertisement
Table of Contents
