Table of Contents
Advertisement
PRIMARY TRANSMISSION SYSTEM 8-12
Spring Cover Bushing Replacement
Under normal use there is no need to replace this bushing.
Mount compressor (P/N 529 035 524) in a vise.
o
Use tools (P/N 529 035 932 and 529 035 931) to
o
remove old bushing.
Bushing must be bonded with retaining compound.
Apply retaining compound Loctite 609 outside of
o
bushing then press it down to counterbore from outside
end.
Insert bushing from sliding half side (inner side) of spring
cover.
REASSEMBLING
NOTICE:
This drive pulley is lubrication free. Do not lubricate any
component.
Screw, Ring gear and Loctite 271
Apply loctite 271 (P/N 412 702 900) on threads and
o
torque to 27 N•m (20 lbf•ft).
CAUTION
CAUTION
Advertisement
Table of Contents
