AD Boivin SNOW-HAWK 800 HO 2007 Shop Manual page 23

Handlebar-Mounted Devices/Switchgears
1. Brake switch
The 2-circuit connector from the brake switch (YL and
YL/WT wires) connects to the 2-circuit connector on the
main wiring harness (YL and WT wires).
2. Dimmer switch
The 3-circuit connector from the dimmer switch (GY, RD/YL
and GY/BK wires) connects to the 3-circuit connector on the
main wiring harness (GY, YL and VI/WT).
3. Tether switch
The 2-circuit connector from the tether switch (BK and
BK/YL wires) connects to the 2-circuit connector on the
main wiring harness (BK and BK/YL wires).
4. Emergency stop switch
The 2-circuit connector from the emergency stop switch (BK
and BK/YL wires) connects to the 2-circuit connector on the
main wiring harness (BK and BK/YL wires).
5. Headlamp Connector
Once all of the connectors are seated, group the handlebar
accessory, headlamp and throttle cable together with a nylon tie
wrap. MAKE SURE that this grouping does not affect the cycling
of the throttle cable or the steering of the vehicle in any way.
Place the emergency stop switch, the dimmer switch and the
brake switch wires underneath the crashpad as shown at right.
WIRE, CABLE AND HOSE ROUTING 16-7
3
1
2
2
4
Tie-wrap
1
3
5