Table of Contents
Advertisement
Feature and report selections (for partition 1)
LOCATION 23 - PARTITION 1, FEATURE AND REPORT SELECTIONS (5 segments, feature selection data)
Location 23 is used to enable certain features that the user can access or see from the keypad
of the system. In addition, certain communicator reports are enabled in location 23. Each of
these features can be enabled by partition. For additional partition information, see locations
88-109.
This location contains 5 segments of 8 features each (see the feature definitions).
Segment 1
Segment 2
Segment 3
Segment 4
NX-4-EUR Installation manual
1 =
On: enables the quick arm feature (for exit and stay mode)
2 =
On: enables the re-exit feature
3 =
On: enables the automatic bypass feature (of interior zones)
4 =
On: enables the silent keypad panic feature (overrides the audible
panic selection)
5 =
On: enables the audible keypad panic feature
6 =
On: enables the keypad Aux 1 feature (FIRE)
7 =
On: enables the keypad Aux 2 feature (MEDICAL)
8 =
On: enables the keypad multiple code attempt tamper feature
(keypad lockout)
1 =
On: enables the LED extinguish feature
2 =
On: enables the require code for bypassing feature
3 =
On: enables the zone bypassed sounder alert feature
4 =
On: enables the AC power/low battery sounder alert feature
5 =
On: enables bypass toggle
6 =
On: enables silent auto arm
7 =
On: enables the automatic instant feature (of entry/exit zones)
8 =
On: enables final set door
1 =
On: enables opening and closing reports
2 =
On: enables zone bypass reporting
3 =
On: enables zone restore reporting
4 =
On: enables zone trouble reporting
5 =
On: enables zone tamper reporting
6 =
On: enables the cancel reporting
7 =
On: enables the recent closing report
8 =
On: enables the exit error report
1 =
On: enables late to close / early to open reporting
2 =
On: enables auto arm in STAY mode
3 =
On: enables instant NIGHT mode (applies to NX-1208E / NX-1248E: no
toggle)
4 =
On: tamper when sensor lost if armed
5 =
On : enables instant STAY mode (toggle)
6 =
On: arming allowed with tamper memory / communication failure/
expander trouble
7 =
On : arming allowed with battery trouble
8 =
On: keyswitch zone arms in STAY mode
Page 44
02/07/06
Hide quick links:
Advertisement
Table of Contents
