Table of Contents
Advertisement
Download parameters
LOCATION 19 - DOWNLOAD ACCESS CODE (8 segments, numerical data)
Location 19 contains the eight-digit access code that the NX-4 must receive from the
downloading software before the panel will allow downloading. The factory default code is
84800000.
LOCATION 20 - NUMBER OF RINGS TO ANSWER (1 segment, numerical data)
Location 20 contains the number of rings to answer for a download. Enter a number from "0"
(disabled) to "15". Factory default is "8", so the NX-4 will answer after 8 rings.
LOCATION 21 - DOWNLOAD CONTROL (1 segment, feature selection data)
Location 21 contains the feature selections to control download sessions. The following
features can be enabled or disabled using this location (see the feature definitions on pages 5-
11).
Segment 1
LOCATION 22 - DOWNLOAD CALL BACK NUMBER (20 segments, numerical data)
If a telephone number is programmed into this location, and "Require Call-back" is enabled in
location 21, the control panel will hang up for approximately 36 seconds (ensuring that the
calling party has disconnected), and then call back. The system will always wait for a dial tone
unless the first digit of the phone number is a "13"; in this case, it will only delay. Tone (DTMF)
dialling is default. If you want pulse tone dialling, program a "15" in the segment where pulse
dialling should begin. If the entire number should be pulse dialling, program a "15" in the first
segment. Four-second delays can be obtained anywhere in the sequence by programming a
"13" in the appropriate delay location.
Note: a zero is programmed as a "0".
WARNING: YOU SHOULD ALWAYS CHECK THAT THE CALLBACK PHONE NUMBER IS
ACCURATE BEFORE DISCONNECTING.
NX-4-EUR Installation manual
1 =
On: enables two call answering machine defeat
2 =
Reserved
3 =
On: requires call-back before download session
4 =
Shutdown (can only be viewed from the keypad; must be changed by
downloading)
5 =
On: locks all local programming. (can only be viewed from the keypad;
must be changed by downloading)
6 =
On: locks programming of all locations associated with the
communicator (can only be viewed from the keypad; must be
changed by downloading)
7 =
On: locks out download section. (If "On", locations 19-22 cannot be
viewed from the keypad; can only be viewed from the keypad when
"Off".)
8 =
On: enables call-back at auto test interval
Page 43
02/07/06
Hide quick links:
Advertisement
Table of Contents
