Table of Contents
Advertisement
LOCATION 43 - GO TO PROGRAM CODE PARTITION AND AUTHORIZATION (2 segments, feature selection data)
The "Go To Program Code" can be used as a standard arm/disarm code. When using the code
to arm or disarm, the user ID is 255. (It is not possible to change this code in the run mode).
Segment 1
Segment 2
LOCATION 44 - DURESS CODE (6 segments, numerical data)
Location 43 contains the "Duress" code. This Location contains either 4 or 6 digits. If the 6-digit
code option is enabled in location 41, THIS CODE MUST CONTAIN SIX (6) DIGITS. If the 6-digit
option is not enabled in location 41, the last 2 digits will be ignored. If the duress code is
programmed, it will work for all partitions.
NX-4-EUR Installation manual
1 =
Reserved
2 =
On: enables "Go To Program Code" as an arm only code
3 =
On: enables "Go To Program Code" as an arm only, after closing
4 =
On: enables "Go To Program Code" as a master arm/disarm code (can
change user codes)
5 =
On: enables "Go To Program Code" as an arm/disarm code
6 =
On: enables "Go To Program Code" to bypass zones
7 =
On: enables "Go To Program Code" opening and closing reports
8 =
Reserved
Reserved
Page 52
02/07/06
Hide quick links:
Advertisement
Table of Contents
