GE NX-4-EUR Installation Manual page 19

[*]-[9]-[3] SET KEYPAD OPTIONS
1.
2.
NX-4-EUR Installation manual
Enter [*]-[9]-[3]
Enter [program code]
OPT
CASE TAMPER ON?
1
Tamper switch of keypad housing active
2 SILENT KEYPAD?
Enable silent keypad option. If this is on, silent keypad is enabled for entry/exit
delay and chime.
DING-DONG CHIME?
3
Enable ding-dong sound for chime. If this is off, the chime will be a single tone.
4 5 SEC. SILENCE?
Enable keypress silence option. Silences the pulsing keypad sounder for 5
seconds when a key is pressed.
5 ARMED ZONE INFO?
Enable armed status suppression. If this is on, the keypad will not display faulted
or bypassed zones when the system is armed.
BEEP ON PANICS?
6
Enable panic, fire, medical beep tone. Will sound a short beep to verify that the
keypress has been accepted.
DISABLE SERVICE?
7
Suppresses the "Service" Message. This will not allow the "Service" message to be
displayed for any reason. If there is a system malfunction (trouble), pressing [*]-
[2] will still display the "Service" menu.
8 MASTER KEYPAD?
Enable multi-partition mode.
9 CUSTOM MESSAGE?
Enable custom message display.
CLOCK?
10
Enable clock display.
11 CUSTOM MSG. LOCK?
Enable custom message lock. Prevents the custom message from being
overwritten during keypad copy.
SELECT AN OPTION
12
1234 - - - -
Page 19
The LCD screen will prompt for a code.
The LCD will now prompt you through the options
listed in the following chart. The current state of the
option will be shown in the lower right corner of the
display. Press [*] to exit the current state without any
changes. Otherwise, follow the directions on the
bottom line to select the desired option. When
finished, press [*] to move to the next option.
KEYPAD FEATURES
02/07/06