Telephone Number 3 - GE NX-4-EUR Installation Manual

Telephone number 3

LOCATION 12 - PROGRAMMING PHONE N° 3 (20 segments, numerical data)
Phone N°3 is programmed in location 12. A "14" indicates the end of the phone number.
Delays of four seconds can be programmed at any point in the phone number by
programming a "13" in the appropriate segment. The system will always wait for a dial tone
unless the first digit of the phone number is a "13"; in this case, it will only delay. Tone (DTMF)
dialling is default. If you want pulse tone dialling, program a "15" in the segment where pulse
dialling should begin. If the entire number should be pulse dialling, program a "15" in the first
segment. Program an "11" for a "*", and a "12" for a "#".
Note: a zero is programmed as a "0".
LOCATION 13 - ACCOUNT CODE FOR PHONE N° 3 (6 segments, numerical data)
Use location 13 to program the account code that is sent when phone N°3 is dialled. A zero in
the account code is programmed as a "0". A "10" indicates the end of the account code, so
program a "10" in the segment immediately after the last digit of the account code. If the
account code is 6 digits long, program all 6 segments. If location 6 is left un-programmed,
account code 1 will be used when phone N°3 is dialled.
LOCATION 14 - COMMUNICATOR FORMAT FOR PHONE N° 3 (1 segment, numerical data)
Location 14 contains the communicator format used to transmit to the receiver that is
connected to phone N°3. Consult the instruction manual for your central station receiver in
order to determine which format is compatible, and select from the 15 formats listed on page
33. If you require a format other than those listed, review the override options described in
location 18 to create the appropriate format. In order to create a special format, a "15" must
be programmed in location 14, in addition to the entries in location 18. If this location contains
a "0", format 1 will be used when phone N°3 is dialled.
LOCATION 15 - DIAL ATTEMPTS/BACKUP CONTROL FOR PHONE N° 3 (2 segments, numerical data)
Segment 1, Dial Attempts: Segment 1 of location 15 is used to enter the number of dial
attempts (1 to 15) that the communicator will make to phone N°3 before it ends the
notification process. Factory default is "0", and the communicator will make the same number
of attempts as those programmed in location 3.
There will be a waiting time of 12 seconds between the first two dial attempts, and a
waiting time of 60 seconds between each subsequent dial attempt (regardless of the
number dialled).
Segment 2, Phone # 3 Backup Control: Programming a "0" in segment 2 of this location will
cause the NX-4 to make the designated number of attempts to phone N°2 before setting the
"Fail To Communicate" condition and stop reporting. Programming a "1" in this segment will
cause the NX-4 to stop trying to communicate after the designated number of attempts have
been made to phone N°3. If a "2" is programmed in this segment, it will cause the NX-4 to
make the dial attempts in increments of two. The first two attempts will be made to phone
N°3, the next two attempts to phone N°2, then repeating until the total number of attempts
designated in segment 1 is completed.
NX-4-EUR Installation manual Page 40 02/07/06