Reporting Events To Phone Number 3 - GE NX-4-EUR Installation Manual

Reporting events to phone number 3

Phone N°3 can be used as a third receiver to multi-report or split report events. Phone N°3 has
two programming locations that are used to select the events that are reported to this phone
number. Location 16 is used to select which events are reported to phone N°3, and location 17
is used to select which partitions are reported to phone N°3. If you do not want dual or split
reporting, location 16 and location 17 should be left at the factory default of "0". If you want
multi-reporting or split reporting, and the split is based on the event type (such as alarm,
open/close, etc.), then location 16 should be used to select only those events that should be
reported to phone N°3, and location 17 should be left at the factory default of "0". If you want
dual or split reporting, and the split is based on partition, then location 16 should be
programmed to "0" and location 17 should be used to select those partitions that are to be
reported to phone N°3. If no events are to be reported to phone N°3, both locations should be
at "0".
LOCATION 16 - EVENTS REPORTED TO PHONE N° 3 (2 segments, feature selection data)
Segment 1
Segment 2
LOCATION 17 - Reserved
NX-4-EUR Installation manual
1 = Alarms
2 = Opening and closings
3 = Zone bypass and bypass restores
4 = Zone trouble and trouble restores
5 = Power fail (AC failure), low battery, power restore (AC restore), and low
battery restore
6 = Bell cut, bell cut restore, telephone line restore
7 = Test reports
8 = Start and end programming, download complete and log full
1 = Zone and box tamper
2 = Auxiliary power overcurrent, and restore
3 = Wireless sensor missing and restore
4 = Wireless sensor low battery and restore
5 = Expander trouble and restore (keypads are considered as expanders)
6 = Fail to communicate
7 = Alarm restore
8 = Tamper restore
Page 41 02/07/06