Adding A Device To Your Home Network Without Assigning It To A Specific Number Key; Adding A Device To Your Home Network And Assign It To A Specific Number Key - GE 45633 User Manual

In order to control the lights, they must be Z-Wave enabled and
you must first add them to your home network. There are several
ways to do this using your primary controller.
1. Add lights so that they can be controlled individually using the
number keys (maximum of 18). Adding a device to a number
key also adds it to your network. If the device number you are
trying to add is already associated with another device, the
previous information will be overwritten.
2. Add devices to your home network without assigning them to
a specific number key. These devices can only be controlled
through the GROUP, SCENE or ALL commands.
3. Add a new light to a Group or Scene.
Add
NOTE: The new device (Light) should be deleted first before adding
to network
Adding A Device To Your Home Network Without Assigning It To
A Specific Number Key:
1. Enter SETUP and select LGHT SETUP.
2. Press OK. The screen will display ADD.
3. Press OK. The screen will display TO NETWORK.
4. Press OK. The screen will display WAITING in the lower right
corner.
5. Press and release the button on the device so that it communi-
cates with the remote.
6. The screen will display SUCCESS to indicate that the Light has
been successfully added.
7. The light can now be added to Groups and/or Scenes.
Adding A Device To Your Home Network And Assigning It To A
Specific Number Key:
1. Enter SETUP and select LGHT SETUP.
2. Press OK. The screen will display ADD.
3. Press OK. The screen will display TO NETWORK.
4. Use either Arrow key to select TO A KEY and then press OK.
5. The display changes to SEL DIGIT.
6. Press a digit key (1-9) for the device location you wish to add.
Remove
To Network
To A key
LGHT SETUP
Delete
11
Label