Replacing The 2.5-Inch Hot-Swap Rear Hard Disk Drive Kit - Lenovo x3550 M5 Installation And Service Manual

2.5-inch hot-swap
rear hard disk
drive kit
Figure 61. 2.5-inch hot-swap rear hard disk drive kit removal
Step 8. If you are instructed to return the rear hard disk drive cage, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.

Replacing the 2.5-inch hot-swap rear hard disk drive kit

Use this information to replace the 2.5-inch hot-swap rear hard disk drive kit.
To replace the 2.5-inch hot-swap rear hard disk drive kit, complete the following steps.
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 116.
Step 2. Turn off the server and peripheral devices and disconnect the power cords.
Step 3. Remove the cover (see "Removing the cover" on page 119).
Step 4. If PCI riser-card assembly 3 needs to be installed (see "Replacing a PCI riser-card assembly" on
page 172), remember to first install the 2.5-inch hot-swap rear hard disk drive kit. Install the kit by
grasping the two handles located on the sides of the kit, and slowly lower it into the chassis. Make
sure that the two alignment pins securely engage the two holes on the side of the chassis.
Attention: Always follow the installation sequence in this step. Failure to do so, may result in
damage to the 2.5-inch hot-swap rear hard disk drive kit.
PCI riser-card
assembly 3
1
Handle
2
.
Chapter 5 Removing and replacing components
143