Prodys PortaNet User Manual page 59

OUTPUTS
Transparent
Line 1 Connected
Line 1 Disconnected
Line 2 Connected
Line 2 Disconnected
Decoder 1 Framed
Decoder 1 NOT framed
Decoder 2 Framed
Decoder 2 NOT framed
Backup Active
Backup NOT Active
Alarm Active
Alarm NOT Active
DTMF detected
Line 1/2 Status
PortaNet User Manual
Under this configuration, the state of the output will be the same
as the corresponding input of the Suprima connected on the
other end.
The output will be activated when the line 1 is connected.
The output will be activated when the line 1 is disconnected.
The output will be activated when the line 2 is connected. It is
only useful when the PortaNet is working in ISDN mode as a
DUAL CODEC.
The output will be activated when the line 2 is disconnected. It is
only useful when the PortaNet is working in ISDN mode as a
DUAL CODEC.
The output will be activated when the Decoder 1 is Framed.
The output will be activated when the Decoder 1 is NOT Framed.
The output will be activated when the Decoder 2 is Framed. It is
only useful when the PortaNet is working in ISDN mode as a
DUAL CODEC.
The output will be activated when the Decoder 2 is NOT Framed.
It is only useful when the PortaNet is working in ISDN mode as a
DUAL CODEC.
The output will be activated when the ISDN Backup is working.
The output will be activated when the ISDN Backup is NOT
working.
The output will be activated when one Alarm is activated.
The output will be activated when there are NOT Alarms
activated.
DTMF is detected by the Decoder.
Line Disconnected: GPO set to '0'.
Line Connected: GPO set to '1'.
Trying/receiving a call: GPO blinking (1 second period).
59 of 156