VII.10.1.1
Establishing a call when PortaNet is configured as an IP
Unicast/Multicast codec
Pressing CALL 1 the screen will display the following:
The user must select which kind of communication will be used:
Unicast Bidirectional
that is, both ends will transmit and receive audio simultaneously. It will be
necessary to check the upload and download bandwidth on the link.
Unicast Unidirectional Tx
communication where only the end which makes the call will send audio.
Unicast Unidirectional Rx
communication, where the calling end will be the receiver.
Multicast Tx
calling end will join a multicast group as a transmitter.
Multicast Rx
calling end will join a multicast group as a receiver.
Next, depending on the selected option will show:
MULTICAST
PortaNet User Manual
L A N L 1 M O D E
{ M U L T I C A S T } U N I C A S T
This is a bidirectional point to point connection,
This is a unidirectional point to point
This is a unidirectional point to point
This is point to multipoint communication in which the
This is point to multipoint communication in which the
L A N L 1 M O D E
{ M U L T I C A S T } U N I C A S T
O
K
L A N L 1 M O D E
{ T x } R x
L A N L 1 D I A L
2 2 4 . 0 . 0 . 2
O
K
39 of 156
Need help?
Do you have a question about the PortaNet and is the answer not in the manual?