Default Ip Addresses - Extron electronics DTP CrossPoint 84 IPCP Programming Manual

Ethernet (LAN) Port
The Ethernet cable can be terminated as a straight-through cable or a crossover cable and
must be properly terminated for your application.
Crossover cable — Direct connection between the computer and the DTP
•
CrossPoint switcher.
• Patch (straight-through) cable — Connection of the DTP CrossPoint switcher to an
Ethernet LAN.

Default IP addresses

To access the DTP CrossPoint switcher via the LAN port, you need the IP address for the
unit, and may need the subnet mask and the gateway address. If the IP address has been
changed to an address comprised of words and characters, you can determine the actual
numeric IP address using the ping (ICMP) utility. If the addresses have not been changed,
the factory-specified defaults are:
• IP address
• Subnet mask
• Gateway address
NOTES:
• The values listed above are the same for all three LAN ports.
• The LAN ports give access to either the DTP CrossPoint or the built-in
IPCP 350 Pro controller.
• The unused ports function as a simple, multiport, unmanaged network switch so
that you can connect additional devices to the same network.
DTP CrossPoint 84
192.168.254.254
255.255.0.0
0.0.0.0
DTP Crosspoint 84 IPCP Series Matrix Switchers • Programming Guide
IPCP 350 Pro
192.168.254.250
255.255.255.0
0.0.0.0
2