Host-To-Switcher Instructions; Switcher-Initiated Messages - Extron electronics DTP CrossPoint 84 IPCP Programming Manual

Host-to-Switcher Instructions

The switcher accepts SIS (Simple Instruction Set) commands through the rear panel
Remote RS-232 port, the front panel Configuration port, and the rear panel Ethernet (LAN)
Port. SIS commands consist of one or more characters per command field. They do not
require any special characters to begin or end the command character sequence. Each
switcher response to an SIS command ends with a carriage return and a line feed (CR/
LF =
characters.

Switcher-initiated Messages

When a local event such as a front panel operation occurs, the switcher responds
by sending a message to the host. The switcher-initiated messages are listed below
(underlined).
The switcher does not expect a response from the host, but, for example, the host program
might request a new status.
(c) Copyright 20yy, Extron Electronics DTPCP84, Vx.xx, 60-nnnn-nn
{day, date, time}
The switcher initiates the
powered up and on a newly connected Internet protocol (IP) port.
version number and
Password:
The switcher initiates the
when the controlling system is connected using TCP/IP or Telnet and the switcher is
password protected. This message means that the switcher requires an administrator or
user level password before it will perform the commands entered via this link. The switcher
repeats the password message response for every entry other than a valid password until a
valid password is entered.
]
]
The switcher initiates the
has been entered. If the user and administrator passwords are the same, the switcher
defaults to administrator privileges.
Qik
The switcher initiates the
Rprnn
The switcher initiates the
front panel. "
Amtnn*x
The switcher initiates the
the front panel.
GrpmDn*y
The switcher initiates the
the control: 1 (Mic Volume) or 2 (Volume)."
Exen
The switcher initiates the
mode) is toggled on or off from the front panel. "
), which signals the end of the response character string. A string is one or more
]
]
Copyright
60-nnnn-nn
]
Password
]
Login Administrator
Login User ]
Login
]
message when a front panel tie creation has occurred.
Qik
]
message when a memory preset has been recalled from the
Rpr
" is the preset number.
nn
]
message when an output audio mute is toggled on or off from
Amt
is the output number and
nn
]
Grpm
]
message when the front panel security lockout (executive
Exe
DTP Crosspoint 84 IPCP Series Matrix Switchers • Programming Guide
message on the Remote RS-232 port when it is first
is the switcher part number.
message immediately after the copyright message
message when a correct administrator or user password
is the mute status: 1 = on, 0 = off.
x
message when a front panel Volume knob is adjusted. "
" is the variable.
y
" is the executive mode: 0, 1, or 2.
n
]
is the firmware
Vx.xx
" is
n
4