Overscan — Lets you select a default overscan mode to apply to SMPTE input rates
•
(480i, 576i, 480p, 576p, 720p, 1080i, 1080p, 2K, and 4K). This zooms and crops
SMPTE inputs to mask edge effects and ancillary data that may occur in broadcast
signals. The selections are
NOTE: If the overscan mode is not 1%, when Auto-Image is performed on an
SMPTE input rate, it refers to the default input values for sizing and centering
instead of performing a true Auto-Image.
•
Factory Reset — Resets the unit to its factory default values (removing any
user-specified values) while retaining the current firmware version.
To reset using the OSD menu, press and hold the
is displayed (approximately 5 seconds). The message remains for approximately
1 minute after the reset is complete to allow time for the display device to sync with
the DSC output.
NOTE: The equivalent SIS command is <ESC>
For other reset methods, see
Communications Submenu
This menu enables you to view the RS-232 remote port baud rate, port type, and the unit
MAC address, and to edit the IP settings.
Figure 30.
(default),
0%
Resetting
Communications Screen
, and
.
2.5%
5%
button until
Enter
<CR>.
ZXXX
on page 41.
DSC HD-HD 4K Plus A Series • Operation
Factory Reset
35