Changing The Output Resolution And Refresh Rate; Custom Rates; Resetting The Output Rate - Extron electronics DSC HD-HD 4K Plus A Series User Manual

•
•

Changing the Output Resolution and Refresh Rate

In addition to the
resolution and refresh rate include resetting the output rate using the front panel
(see
commands
help file).

Custom Rates

In addition to the 80 factory output resolutions, three custom user-defined rates are
available. Using SIS commands, the
or the PCS software program, you can capture the EDID of the device connected to the
HDMI output or upload a custom EDID file from a computer (see the
commands
are defined, these three resolutions and rates default to 1080p @ 60 Hz.
The OSD dynamically updates based on the current file stored in the custom EDID
slot. For example, if a custom 720p EDID has been uploaded, the OSD would display
C1: 1280x720 @ 60 Hz
for more information.
When you set this resolution using the menu system, a confirmation prompt appears. If
you do not respond to the prompt by pressing
to the previous resolution.

Resetting the Output Rate

If an output image cannot be displayed due to an incompatible output rate, you
can use the front panel down arrow
1024x768 @ 60 Hz (XGA) and 1280x720 (720p) @ 60 Hz. To set the rate or toggle
between the two rates:
1.
2.
NOTE:
SIS commands (see the Auto-Image commands
PCS software (see the program help file).
Output submenu
Resetting the Output Rate), SIS commands (see the
beginning on page 57), and the PCS software program (see the program
on page 57 or the PCS software program help file). When no custom EDIDs
. See the
Ensure that the OSD is closed by pressing and holding

Press and hold the button until a message appears on the display indicating the
new rate (approximately 5 seconds).
On the front panel, the
on page 52).
(see page 28), other methods for setting the output
Capture Display EDID
Output Rate item of the
Output
within 20 seconds, the DSC reverts
Enter

button to toggle the output rate between

button is labeled
Hold
DSC HD-HD 4K Plus A Series • Operation

button
Output Configuration
item on the submenu,
Input
Output Scaler Rate
submenu on page 28
for 3 seconds.
Menu

.
for XGA/720p
38