Extron electronics DSC HD-HD 4K Plus A Series User Manual page 38

• Output Format — This item lets you set the HDMI output format and control the
output colorspace.
To select the format:
1. Select
Output Format

2. Press the or

3. Press to confirm your selection.
Enter
4. Press to return to the
t
The format choices are:
• (based on the EDID of the sink) (default)
Auto
•
DVI RGB 444
•
HDMI RGB 444 Full
•
HDMI RGB 444 Ltd
•
HDMI YUV 444 Ltd
•
HDMI YUV 422 Ltd
•
HDMI YUV 420 Ltd
HDCP Notification — This item lets you select what is displayed on the HDMI
•
output when the input signal contains HDCP-protected content and the output is a
non-HDCP sink. After pressing
buttons to select between:
— Displays a green screen with the message
• Green w/OSD
HDMI output display (default).
— Displays a black screen and the output sync is maintained.
• Black Screen
— Displays a user-uploaded image. To upload images, use the PCS
• User File
software screen (see the program help file for the procedure).
Logo
• Input AFL — This item lets you enable and disable the Extron Accu-RATE Frame
Lock (AFL). After pressing
to toggle Input AFL on and off. The default is
When is selected, frame lock mode locks the output vertical refresh rate to the
On
vertical refresh rate of the currently selected input using Accu-RATE Frame Lock
technology. This ensures no frames of the input are repeated or dropped due to frame
rate conversion. Input AFL mode can cause glitches or interruptions in the output
sync when a new signal has been routed to the input, because the DSC locks to the
new vertical refresh rate.
NOTE: AFL locks the output refresh rate to the vertical rate of the input signal
only if they are similar frequencies. If the input refresh rate greatly differs from the
set output resolution, the DSC may not output a signal or may blink.
• Logo — Select this item to enable or disable display of a user-uploaded logo image.
There are 16 slots available for storing logo files. To upload a logo file to the unit, use
the page of the PCS configuration program (see the program help file for the
Logo
procedure).
To select a logo to display:
1. Select from the
Logo
2.
Press the button to move the yellow selection arrows to the logo names list.

from the submenu and press
Output
buttons to select the format.
submenu.
Output
to select this item, press the
Enter
to select this item, press the
Enter
.
Off
menu and press
Output
DSC HD-HD 4K Plus A • Operation
.
Enter

or arrow

HDCP Content

or arrow buttons

.
Enter
on the
30