Specifications - Strong SRT 7806 User Manual

NEVER open or disassemble your receiver. This may cause a dangerous situation and will void the
warranty.
Symptom
The standby indicator
does not light up
There is no image, no
sound, no display
There are small blocks in
the video, occasionally
no sound, occasionally
no signal
Scrambled channel
message
No response to remote
control
Password forgotten
The external USB HDD
does not start.
The receiver switches to
standby automatically.

9.0 SPECIFICATIONS

Demodulator
Demodulation:
Input symbol rate:
FEC decoder:
video
Profile level:
Max. video resolution:
Aspect ratio:
22
Cause
The mains lead is unplugged/the
multipoint connector is switched off.
There is no power supply
There is a short circuit in coaxial
cable
Cables are missing or defective.
A wrong video format was selected
in the OSD settings
The signal is too weak
The channel is scrambled.
The receiver is off.
The handset is not aimed correctly.
The IR sensor is obstructed.
The handset batteries are
exhausted.
The default password is 0000
The power consumption is too
high.
The Auto Standby function is
activated and has reached the set
time (default 3 hours).
QPSK, 8PSK
DVB-S QPSK: 1 ~ 45 Ms/s
DVB-S2 8PSK/QPSK: 1 ~ 45 Ms/s
Auto, 1/2, 2/3, 3/4, 5/6, 7/8 in DVB-S mode
1/4, 1/3, 2/5, 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, 9/10 in DVB-S2 QPSK mode
3/5, 2/3, 3/4, 5/6, 8/9, 9/10 in DVB-S2 8PSK mode
MPEG-2 MP@ML, MPEG-4 AVC high profile H.264 HP@L4.1/MP@L4.1
1920x1080p
4:3 and 16:9, Pan & Scan Automatic adjustment for 16:9 TV sets,
Letterbox supported
Remedy
Check the mains lead/switch the
multipoint connector on.
Check the connection cables
Disconnect device from mains power
supply, eliminate the short circuit
in the coaxial cable or connections,
reconnect, and activate device
Check your connecting cables
Check the settings to make sure your
TV supports the selected format
Check for defective cables or
connectors. Alternatively, reduce the
coaxial cable length
Select an alternative channel.
Plug in and turn on the plug.
Aim the handset at the IR sensor.
Check for obstructions.
Replace the handset batteries.
Contact the local Service Hotline
or send an email to our support via
www.strong.tv
Connect an extra power supply
adapter to your USB HDD device.
Set the power down time or disable
it in the SettingsTime Setting menu,
parameter Auto Standby After.