Basic Connection Using A Scart Cable; Connecting To The Internet; Connection To Main Power Supply; Starting Up For The First Time - Strong SRT 7806 User Manual

a. Connect the LNB of your satellite antenna to the SAT IN connector of your receiver using a good
quality coaxial cable and suitable 'F-connector' plugs.
b. Connect one end of a good quality HDMI cable to the HDMI output on your receiver and the other end
to the HDMI input of your TV.
c. Plug the power adapter to a suitable wall outlet.

3.4 basic connection using a SCART cable

a. Connect the LNB of your satellite antenna to the SAT IN connector of your receiver using a good
quality coax cable and suitable 'F-connector' plugs.
b. Connect one end of a good quality Scart cable to the TV SCART connector on your receiver and the
other end to the SCART input of your TV.
c. Plug the power adapter to a suitable wall outlet.

3.5 Connecting to the Internet

The receiver connects to the Internet through the Internet router or DSL/cable modem in your home
network. It connects to the home network over its Ethernet port.
Connect one end of the Ethernet cable to the receiver and the other end to the LAN port at the router or
DSL/cable modem.

3.6 Connection to main power supply

After all the connections are done you can connect your receiver to power using the supplied external
AC/DC adapter. Now plug the adapter into the wall socket.

4.0 STARTING UP FOR THE FIRST TIME

Once you properly installed and connected all cables of the receiver, setup your receiver step by step by
First Time Installation procedure.
It will guide you through the basic installation and channel searching process.

4.1 Language selection

Select your preferred language for the on screen menu.
Use p q to change language and press Ok to confirm your selection.

4.2 Antenna Settings

4.2.1 Satellite selection
To set up the receiver for the type of connected antenna, follow the instructions below.
You have technical possibility to configure your receiver to get signal from up to 4 satellites. Select LNB
to set specific satellite or leave it unassigned. Select the satellites you wish to receive with the receiver.
Each of the satellites in the built-in satellite list is configured with predefined default parameters. You
could use RED button to perform Dish setting for selected satellite,
step and GREEN button to continue (refer chapter 4.3 Channel Search). In case you use just Astra 19.2E
satellite, you could skip this step and also press GREEN button.
LNB 1 Select Astra 19.2E or Astra 23.5E satellite. Default value for LNB1 is Astra 19.2E.
LNB 2 – 4 Select from the list additional satellites from which you wish to view channels with
your receiver. Default value for LNB2 is Hotbird 13E. Default value for LNB3 and LNB4 is
Not assigned.
button to return to previous
Fig. 8
Fig.9
Fig. 9
7