Troubleshooting - Strong SRT 7806 User Manual

After configuring, press RED to start the scanning with the selected settings.
Your receiver will now perform an automatic channel search. The scanning progress is displayed. During
the channel search you can skip transponders by pressing the MENU button or quit the scanning
process by pressing (required confirmation).
By the time the process is completed, all listed channels will be stored and the receiver will switch to the
first channel.
7.5.3 Information
This submenu shows all receiver related information e.g. hardware and software version. It also displays
technical information from the currently selected channel, signal strength and signal quality.
Please refer to the information given on screen when you call a hotline support. The support center
employee might ask for the information given on screen.
7.5.4 Factory Default
This submenu allows you to reset your receiver to the default factory settings. You will be asked to enter
the PIN code (default PIN code is 0000). Select Factory Reset to delete all settings and channels. Press Ok
to confirm. Select Channel Reset to delete all channels. Press Ok to confirm. All previous settings will not
be changed.
The receiver will reboot and start with the First Installation menu.
WARNING:
A factory reset will permanently delete all your personal settings, timers and stored
channels. Please consider this before you perform a factory reset. Please use this
option with caution.
7.5.5 CA INFO
Smartcard Information
This menu section is only accessible when an HD+ smartcard is inserted into the receiver. It provides
information about the HD+ smartcard. Please consult your installer or card provider for information
regarding the usage of your HD+ smartcard.
NOTE:
Always make sure to insert the smartcard with the golden chip facing down.
Mail List
This submenu allows you to read messages from the operator.
NOTE:
Messages from the operator will be displayed at the upper left corner of the TV
screen, showing the
to read the message.
Use the p q buttons to select the message and press Ok to open and read it. Press RED to delete all
messages from the list. Press GREEN to move up one page in the list. Press YELLOW to move down one
page in the list. Press bLUE to delete the selected message. Press
Press to exit the menu and go back to viewing mode.

8.0 TROUbLESHOOTING

There may be various reasons for faulty operation of the receiver. Please check the receiver according
to the procedures shown below. If the receiver does not work properly after checking it, please contact
your local service line or STRONG dealer. Alternatively you can send a support e-mail via our website:
www.strong.tv.
icon. Press on the remote control or open the submenu
button to return to previous step.
21