Table of Contents
Advertisement
NOTE:
SatCR can only work in combination with an optional multi-output (max. 8) satellite
splitter and a SatCR LNB, an example is STRONG type SRT L780 (max. 4 users).
NOTE:
SatCR cannot be combined with any other DiSEqC function. SatCR systems are
mainly installed by professional experts.
7.5.2 Channel Search
The channel search procedure from the menu is almost the same as described in First Time Installation
chapter 4.3. This section contains more detailed information on how to add, modify or update your
channel list. In order to view video programmes, you must do a channel search with or without
smartcard in order to install the channel list of your choice. For HD+ channels, first insert HD+ smartcard
at the side panel of the receiver before you start the channel search. Then the receiver will install the
associated channel list of the HD+ bouquet (FTA and encrypted). For FTA channels only or for channels
from other satellites you do not need to insert the HD+ smartcard.
Select the search scheme you wish the wizard to follow:
1. Select HD+ channels to search for channels of the HD+ bouquet (channels numbered 100 and
above).
2. Select Preinstalled channels to restore a predefined German channel list from the receiver's
memory (channels numbered 1~99).
3. Select Advanced channel search to search for channels on all/selected transponders for the
selected satellite (channels numbered above HD+ bouquet numbers).
Use the p q buttons to select the required search scheme. Use the t u buttons when you want to
change the value or press Ok to select it from the list. Use GREEN to perform an HD+ channel update.
Use RED to restore the original HD+ channel list.
Use the
button to return to the previous step. Press
mode.
NOTE:
If the messages No list found or No channels found are displayed, please check
the antenna connections, select correct satellite and check signal level and other
parameters from the satellite dish for selected satellites, as described in chapter 7.5.1.
Advanced channel search
Satellite:
Select a satellite to be configured and scanned.
Transponder:
Select the transponder you want to scan from the list of existing transponders.
Press RED to edit the parameters of the selected transponder. Press GREEN to add
a new transponder. Press YELLOW to delete the selected transponder (required
confirmation).
Frequency:
Get information about the transponder frequency.
Get information about the symbol rate of the selected transponder.
Symbol:
Polarization:
Get information about the polarization of the selected transponder.
Search Mode:
Select the channels that shall be installed. Available options: Free, Scrambled or All.
Select the type of channels that shall be installed. Available options: TV, Radio or
Channel Type:
TV&Radio.
Search on::
Select where to search for new channels. Available options: One Transponder, One
Satellite or Selected Satellites.
The Signal Strength and Signal Quality indicators on the 2nd half of the screen will help you to make sure
that you get the signal with the selected parameters, as well as to adjust the antenna if necessary.
20
to exit the menu and to go back to the viewing
Advertisement
Table of Contents
