Accessories; Usage Of External Usb Devices; Your Receiver 2.1 Default Pin-Code: 0000; Front Panel - Strong SRT 7806 User Manual

NOTE
Indicates any other additional important or helpful information.
MENU Represents a button on the remote control or the receiver. (bOLD CHARACTERS)
Represents a menu item within a screen. (Italic characters)
Move to

1.4 Accessories

1x user manual
„ „
1x remote control unit
„ „
2x 1.5 V batteries
„ „
1x adapter 12 V, 1.5 A
„ „
1x HD+ smartcard
„ „

1.5 Usage of external USb devices

It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
„ „
specifications, the playback with your receiver might not work properly.
If you are going to use external USB HDD (Hard Disk Drive) please consider that the power
„ „
specifications might exceed the supported output of your receiver (5 V/800 mA). If so, please
connect your USB HDD to an according external power adapter.
STRONG cannot guarantee compatibility with all types of USB storage devices.
„ „
It is advised not to store important information on USB storage devices used with the
„ „
receiver. Always make backups of data on your USB storage device before using it with this
receiver. STRONG will not take responsibility for any loss of information or circumstances
caused by loss of information.
Please ensure that either the USB device is already formatted to NTFS or FAT32 or format the
„ „
USB device via your receiver. Formatting requires entering the PIN code (default 0000)
STRONG cannot guarantee the playback of all files although extensions are listed, as it
„ „
depends on file size, codec, bit rate and resolution.
2.0 YOUR RECEIvER
2.1 DEFAULT PIN-CODE: 0000

2.2 Front Panel

1. Power button
2. P-/P+:
3. LED Display Displays channel number, time, videotext page or recording modes
4. Standby indicator:
5. USb

2.3 Side Panel

1. Smart card slot

2.4 Rear Panel

1. SAT IN
2. S/PDIF (coax.)
4
Switch the receiver to Standby or On
To change channels without using the remote control
Shows power state of the receiver: Red LED - receiver is in standby mode
To connect your USB storage device
To insert your HD+ smart card with the golden chip facing down.
To connect to the LNB of your satellite antenna for reception of satellite broadcast
signal
To connect to a digital amplifier or home theatre using a coaxial cable
Fig.1
Fig.2
Fig. 3