Printed Image Trouble - Kyocera 7002i Operation Manual

Troubleshooting > Troubleshooting

Printed Image Trouble

When the following printed image trouble occurs, implement appropriate procedures.
Symptom
Printed images are totally
too light.
Printed images are too
dark even though the
background of the
scanned original is white.
Copies have a moire
pattern (dots grouped
together in patterns and
not aligned uniformly).
Texts are not clearly
printed.
Checkpoints
Is the paper damp?
Have you changed the density?
Is the toner distributed evenly within
the toner container?
Is there a message on the screen
about adding the toner?
Is EcoPrint mode enabled?
―
―
―
―
Have you changed the density?
―
―
―
Is the original a printed photograph? When making copies
―
Did you choose appropriate image
quality for the original?
―
Corrective Actions
Replace the paper with new paper.
Select appropriate density level.
To adjust the overall density, use
[Adjustment/Maintenance] on the
System Menu and adjust the density
as required.
Shake the toner container from side
to side several times.
Replace the toner container.
Disable [EcoPrint] mode.
Make sure the paper type setting is
correct for the paper being used.
Run [Calibration].
Run [Drum Refresh 1].
Run [Developer Refresh].
Select appropriate density level.
Run [Calibration].
Run [Drum Refresh 1].
Run [Developer Refresh].
Set the original image to
[Printer Output] or [Book/
Magazine] in [Photo].
When making copies
Select [-1] to [-3] in [Sharpness].
Select appropriate image quality.
When making copies
Select [-1] to [-3] in [Sharpness].
10-20
Reference
Page
page 3-2
page 6-31
page 8-70
page 10-5
page 10-4
page 8-19
page 8-15
page 10-42
page 10-41
page 10-42
page 6-31
page 8-70
page 10-42
page 10-41
page 10-42
page 6-31
page 6-33
page 6-31
page 6-33