Place The Originals - Kyocera 7002i Operation Manual

Hide thumbs Also See for 7002i:

Table of Contents

Operation on the Machine > Loading Originals

Place the originals.

Put the side to be scanned (or the first side of two-sided originals) face-up. Slide the

leading edge into the document processor as far as it will go. The original loaded indicator

lights when the original is placed correctly.

For details on Original Orientation, refer to the following:

Original Orientation (page 6-23)

• Confirm that the original width guides exactly fit the originals. If there is a gap,

readjust the original width guides. The gap may cause the originals to jam.

• Ensure that loaded originals do not exceed the level indicator. Exceeding the

maximum level may cause the originals to jam.

• Originals with punched holes or perforated lines should be placed in such a way

that the holes or perforations will be scanned last (not first).

Open the original stopper to fit the size of the original set (Original size: B4/Legal or more).