Closing Lid’s Preparation And Installation - Quick BTR250 User Manual

Closing lid's preparation and installation
WARNING: pay particular attention to avoid interferences between the lid and the hull opening. Too precise contacts will
cause damages to the entire moving system.
Fig. 7
Fig. 9
LID'S
BRACKET
LID
Fig. 10A
COUNTER FLANGE
ANGLE BAR
HINGE
LID
36 mm
60 mm
RETRACTABLE THRUSTER BTR250 - IT EN - REV08B
Fig. 8
ANGLE BAR
Fig. 10B
A
HULL
C1
3 SCREWS M8
COUNTER FLANGE
LID
45°
• Make the closing lid by keeping on all sides a space
varying from 3 to 5 mm (fig. 7), paying special atten-
tion to the hinge's side, ensuring that the internal
walls are inclined by 45° so that they don't hinder the
HINGE
hull's opening (fig. 8).
• To obtain the correct opening of the hinge, the sur-
faces of hull and lid must be on the same level (fig. 9).
HULL
• Position the angle bar correctly on the hull
(fig. 10A+10B - part. A).
Fasten the angle bar with structural adhesive
(fig. 10B - part. B1-B2).
Decide whether to fasten the lid bracket to the hull
with 3 M8 screws or with resin (fig. 10B - part. C1-C2).
ANGLE BAR COUNTER FLANGE
C2
INSTALLATION
HULL
5 mm
B1
STRUCTURAL
ADHESIVE
ANGLE BAR
GRP LAYERS
EN
ANGLE BAR
B2
25