Table of Contents
Advertisement
Available languages
Available languages
5 - Installation
5.0 - Thruster
• The thruster can be installed at any angle within
90° from vertical.
• The hydraulic motor needs no support.
•
Use the flange to mark the centre of the holes on
the tube.
F
N.B. All holes must be exactly aligned with the half-way point of the tunnel, since tolerance between pro-
peller and tunnel is minimal.
• Take care that there are no resin residues in the contact area between flange and tube; this could cause misali-
gnment. Any resin residues and any other hindrance to correct contact must be removed by sandpaper.
• To position the thruster in the tube, find the half-
way point.
• Fix the drilling template on the reference points,
making sure they are aligned with precision at the
half-way point of the tube.
INSTALLATION AND USE MANUAL BTH386 - REV003C
0
1
2
3
4
5
6
7
EN
BTH 386
455 - 580
8
9
10
23
Advertisement
Table of Contents
