Connection Settings - ZyXEL Communications max318m2w User Manual

6.2 Connection Settings

This screen allows you to configure how the WiMAX Device connects to the base
stations on the WiMAX network.
Click WiMAX > Profile > Connection Settings to open this screen as shown
next.
Figure 21 Connection Settings Screen
This screen contains the following fields:
Table 15 Connection Settings
LABEL
Connection Option Settings
Auto
Reconnect
Auto
Connect
Mode
Enable
Handover
Enable Idle
Mode
Idle Mode
Interval
MAX318M2W User's Guide
DESCRIPTION
Select the interval in seconds that the WiMAX Device waits after getting
disconnected from the base station before attempting to reconnect.
Select the auto connect mode.
• By channel power - Auto connects to the base station if the signal
strength of the channel is sufficient for the WiMAX Device.
• By CINR - Auto connects to the base station if the signal-to-noise
ratio is sufficient for the WiMAX Device.
Select this to maintain connectivity while the WiMAX Device switches its
connection from one base station to another base station.
Select this to have the WiMAX Device enter the idle mode after it has no
traffic passing through for a pre-defined period. Make sure your base
station also supports this before selecting this.
Set the idle duration in minutes. This is how long the WiMAX Device
waits during periods of no activity before going into idle mode.
Chapter 6 WiMAX
67