Table of Contents
Advertisement
Chapter 10 The VoIP Account Screens
Table 53 VoIP > Account 1 (or Account 2) > Feature
LABEL
MWI
Hold Method
DTMF
DTMF
SIP INFO
Call Forward Setting
Enable call
Forwarding
Unconditional
CF,
Unconditional
CF Target
Busy CF,
Busy CF
Target
No Answer CF,
No Answer CF
Target
Call Waiting Setting
Call waiting
148
DESCRIPTION
Select this to enable Message Waiting Indicator (MWI) mode for this
phone line. The WiMAX Device sends a beeping tone to the phone
when there is at least one voicemail for the number.
Select the method to use when a call is put on hold.
sendonly/recvonly - Select this to allow the WiMAX Device to send
voice packets only but disallow to receive any voice packets. The peer
end should change to a state which allows to receive voice packets
from the WiMAX Device only but disallow to send any voice packets.
inactive - Select this to disallow the WiMAX Device send or receive
any voice packets.
Control how the WiMAX Device handles the tones that the phone
using this extension makes when you push its buttons. One use of the
tones is to distinguish between numbers when trying to dial a PSTN
phone number.
You should use the same mode as your VoIP service provider. The
choices are:
• Out-of-band(RFC 2833) - Follow the RFC 2833 standard and send
the DTMF tones in RTP packets.
• In Band - Send the DTMF tones in the voice data stream. This
works best when you are using a codec that does not use compression
(like G.711). Codecs that use compression (like G.729) can distort the
tones.
Select this to have the WiMAX Device send the DTMF tones in SIP
messages.
Select this check box to enable call forward.
Select this if you want the WiMAX Device to forward all incoming calls
to the specified phone number, regardless of other rules in this Call
Forward Setting section. Specify the phone number in the
Unconditional CF Target field.
Select this if you want the WiMAX Device to forward incoming calls to
the specified phone number if the phone port is busy. Specify the
phone number in the Busy CF Target field. If you have call waiting,
the incoming call is forwarded to the specified phone number if you
reject or ignore the second incoming call.
Select this if you want the WiMAX Device to forward incoming calls to
the specified phone number if the call is unanswered. Specify the
phone number in the No Answer CF Target field on the right.
Select this to enable call waiting
Device.
for this SIP account
on the WiMAX
MAX318M2W User's Guide
Advertisement
Table of Contents
